Winter is here and that means cold temperatures, snow and ice. And for those who rely on their cars to get around, it also means one more thing: the dreaded dead battery. But what if I told you that there’s a startup company that has a solution to help keep you from getting stuck in the cold? Read on to find out how!

This is frequently due to a weakening battery if the car stops working the service.
This also reveals an appearance at the breakdown statistics of the ADAC.
If the club’s road watchers have to vacate, the use involves an empty starter battery in nearly half of all cases.
The automatic light shutdown from modern-day cars, the standard mistake of yore prevents the headlights from being shaken after the automobile.
To do this, the automobiles these days run significantly more electrical consumers and control units than previously.
Especially in winter, the power storage is exposed to strong stress: at minus ten degrees it loses about a third of its strength.

breakdown helpers, booster or bridging cable television

There are different alternatives to help the battery back on the jumps.
The most convenient: you notify a breakdown assistant.
The option is self-help.
Either a starting aid device (likewise called Booster or Jump Starter), a type of power bank for the vehicle supports that preferably fully charged in the trunk and, if essential, is clamped onto the battery.
Or a bridging cable television (DIN standard 72,553 or ISO basic 6722) along with a 2nd vehicle as a donor truck.

it depends on the order

In the latter case, it makes good sense to first make sure where the batteries of the 2 vehicles are set up.
Since donor and receiver car must be placed so that the poles can be conveniently connected to each other.
With additional procedures, the right order should be observed:
Step 1: Turn off the ignition of both cars.
Take the red plus cable on hand and connect to the plus pole of the donor and the donor cars and truck.
Step 2: Clamp the black minus cable to the minus pole of the donor battery and with the other end to an unpainted metal part on the engine block of the recipient vehicle or to an intended mass point (see operating guidelines)- however if necessary on the battery, otherwise spark flight threatens.
Step 3: Start the engine of the donor truck and let it run for about ten minutes.
Step 4: Leave the breakdown cars and truck.
If it does not start, the start attempt is canceled and repeated after about a minute.
If there are a number of attempts without the preferred success, you ought to let the start help campaign be and consult an expert from the motor vehicle workshop or a breakdown assistant.
The battery may not be the issue.
More beginning attempts can lead to damage.
Step 5: The engine runs, switch on consumers with high electrical power requirements such as light, blower or rear disc heating.
This prevents tension and protects the on-board electronic devices.
Action 6: Disconnect the cable televisions once again, in reverse order.
So: Very first remove the black minus cable from the donor vehicle, then from the recipient.
Loosen up the red plus cable.
Change off or manage the existing electricity consumers once again.
Step 7: The breakdown cars and truck moves a minimum of half, however better for an hour on the back road or the highway to guarantee that the battery is loaded sufficiently to guarantee a brand-new starting procedure.
Activate as a couple of electrical consumers as possible.

Better reload

The Vehicle Club (ACE) cautions of a completely charged battery.
Your advice: Load the automobile battery with a charger and have a specialist workshop looked for security factors.

and what about the electric cars and truck?

In addition to its traction battery, which provides the electric motor with driving present, e-cars likewise have a traditional starter battery that triggers the high-voltage system.
This 12-volt battery might be empty.
The electrical vehicle can get start-up help, either by booster or from another car.
The procedure represents the one explained above.

The opposite case is harder, i.e. to use the electric car as an energy dispenser.
Reason: The 12-volt battery of the electrical power is rather small, there is a threat of overload and damage.


Numerous makers therefore do not enable the start-up help.
Prior to it takes location, the operating directions must be spoken with.